Halder - EH 23220.: Supporting Elements

The support element is used to support additional clamping points on components.

The benefits of the support element are:

• provides additional support without distortion
• helps to eliminate tool vibration
• supports ribs, beads and shackles to reinforce clamped components
• distortion-free support of raw parts

Material

Housing

• Aluminium

Body

• Case hardened steel, nitrided, manganese phosphate treated and ground

Assembly

Fix the support element (2 x M 6 thread) onto the device. Pay attention to the operator's side!

Alternative: Dismantle the M 12 x 10 threaded pin and replace it by an M 12 x 30 threaded pin and assemble the support element with a wrench (WS 21), e.g. for T-slot mounting (no defined operator's side ensured). Threaded pin M 12 x 30 and T-nut DIN 508 M 12 x 14, quality 10, are part of the standard supply volume.

Lowering of the support element by 16 mm is possible.

Operation

By turning the clamping cam (WS 6 internal hexagon) on the outer surface of the red protective sleeve, the support pin contacts the workpiece with a slight spring load.

• By turning on (15 Nm) as far as possible (lock), total of 180°, the clamping mechanism locks the support pin without moving. The support element has been placed onto the workpiece and locked.
• If turned in the opposite direction (unlock), the clamping is released. If turned back as far as possible, i.e. total of 180° the support pin moves to the end position.

Notes

For safe functioning, the thread bore M 12 must always be closed.

References

Additional flexible possibility of fitting with holding plate 23210.0740.

The M 8 threaded pin on the support bolt can be replaced by various locating and seating pins (EH 22...). Customer-made extensions can also be fitted.