Halder - EH 23271.: Eccentric Clamps

The eccentric clamp allows clamping with pull-down effect on different workpiece forms at low height.

Material

• Case-hardened steel, case-hardened and blue zinc-plated

Assembly

• Manufacture a thread with the corresponding distance L2 / L3 to the workpiece.
• Screw in the eccentric clamp at the necessary height and set it relative to the workpiece with its flat side.
• Insert the workpiece and tighten the clamping pin using the internal hexagon. The proper tension is achieved after approx. 1/3 turn.

The threaded hole must be lubricated on a regular basis.

The rotational movement during tightening must always be completed towards the stops in order to prevent the workpiece from turning away from the stops.